SALUS NanoWalk
- Floor Protectant

Salus NanoWalk is a unique fusion of Aliphatic polyester sealers and Nano-metal oxides to densify and optimize resiliency. The same Nano-metal oxides that neutralize VOCs and improve IAQ in Salus other smart coatings.

BENEFITS:

• Very low odor, VOC compliant

• Tensile strength, PSI 7000 100%

• Modulus, PSI 4000

• Elongation % 300

• Dry Slip Resistance ASTM-D-2047

• Wet Slip Resistance ANSI A137.1

• Dry Film Static Control 100%

WHERE TO USE:

• VCT 

• LVT

• Sheet Vinyl 

• Rubber 

• Poured Polymer (Epoxy) 

• Terrazzo 

• Marble 

• Granite 

• Existing Concrete Floors (Polished or Brush Finished) 

• Prefinished Wood

  
  

DIRECTIONS:

• Thoroughly Clean, then neutralize the surface a neutral cleaner.

• Allow the floor to dry.

• Shake Salus™ NanoWalk well before each use.

• Apply three or four very thin coats with a micro-fiber pad or wax applicator.

• Cure for 20 minutes between coats.

• 1 Liter yields approximately 45 square meters (3-4 coats minimum)

• For an extremely long-lasting finish, apply 4-5 coats before burnishing.

• Salus NanoWalk finish does not need buffing, however, if you wish to buff, wait 2-4 hours after application.

• The floor is serviceable 20 to 30 minutes after the final coat.

• For existing floors, strip old finish to bare floor before applying NanoWalk following above steps.

TESTIMONIALS:

SPORTS COMPLEX DRESSING ROOM

OFFICE BUILDING RESTROOM

Salus NanoWalk on ceramic tile in office building restrooms in Chicago. Applied on top of abraded 

Never Wax “never wax again” polyaspartic floor finish, yellowed and scuffed after 10 years.

FOR ALL HARD FLOOR SURFACES

Salus NanoWalk works to enhance and strengthen any hard surface floor; including rubber modular, profiled rubber tile, roll rubber, linoleum, ceramic, terrazzo, polished stone or polished concrete.

Improved wet and dry slip, repairable, refreshable, burnish-able.

IMAGE 1:

TDS pdf